EASY TO APPLY IKEA STICKERS

HOW TO GUIDE

HOW TO VIDEOS:

LATT TABLE - HOW TO - CLICK HERE

FLISAT TABLE TOPS - HOW TO VIDEO - CLICK HERE

How to apply TROFAST Stickers

STEP 1 - Wipe and dry off the area where you want to place your sticker. IMPORTANT

Wipe and dry off the area where you want to place your wrap. Take a baby wipe or water-soaked towel and clear away any dust, wax, and debris from the surface of your Trofast storage box. Try to get the area as smooth and clean as possible, so no dust or grime adheres to your vinyl sticker later on. If the area is especially dirty, add a pea-sized amount of delicate soap to your damp towel to get the surface squeaky clean.

If your desired sticker area already looks clean, just give it a quick wipe down.

STEP 2 - Peel away

Peel away the backing tape on the sticker. Use your thumb and pointer finger to pry the back paper from the surface of the sticker. As you peel away the paper, pinch the vertical edges of the sticker with your opposite hand. Once the back paper is completely removed, hold the sticker with the thumb and pointer finger of each hand.

Avoid touching or holding the back surface of the vinyl sticker.
Pinch the vertical edges of the vinyl sticker as you place it down.

Pinch the vertical edges of the vinyl sticker as you place it down. Continue holding the sticker securely as you place it onto the dry Trofast surface. Try applying the center of the sticker first, then press the outer edges of the vinyl sticker into place. Aim to do this in a fluid motion to prevent any air bubbles from forming.

you should be applying your sticker to a clean dry surface, make sure that it’s positioned and angled properly.

STEP 3 - Press out any air bubbles with a squeegee or your hands will do the trick.

Press out any air bubbles with a squeegee or your hands. Move your hands or squeegee applying an even amount of pressure as you go from edge to edge. Focus on areas that have air bubbles, so the sticker looks smooth. I then press my hands firmly along with the edges and across the vinyl wraps followed by pressing down on the edges.

** The unlikely event of lifting corners **

In the unlikely event of peeling corners - Don’t be discouraged it can be that there was a missed bit of dust or dirt. Turn a hairdryer to a low setting, and run the device several inches or centimetres above the surface of the sticker. Beneath the added heat, use your hand to help the sticker apply correctly to the curved edge.